CE Marking of structural steelwork is a declaration that our products meet necessary public safety requirements.
The public safety requirements are a set of essential characteristics that each product must satisfy and these characteristics are given in the product’s harmonised standard.
CE Marking of construction products was introduced in the Construction Products Directive (CPD) in 1988. In the UK the CPD was enforced by the Construction Products Regulations 1991 (CPR) which described the two tests for compliance with the CPD. The first was CE Marking and the second was supplying, when asked, Trading Standards Officers all the information required on the product to enable the authorities to satisfy themselves that the product complies with the regulations and the requirements of the CPD.
Since 1st July 2013, the CPR made CE Marking mandatory in the UK and Republic of Ireland, for all construction products that are permanently incorporated in to a building or civil engineering works and are covered by either a harmonised standard or European Technical Assessment.
On 1st July 2014, CE Marking became enacted on all structural steelwork for construction and civil engineering.
rojects. The Scope of works covered by the harmonised standard (EN1090-1) has been detailed by the British Standards Institute (BSI.) A copy of BSI’s Scope is attached to this section of the website.
This affects every construction project from a simple domestic house extension to the Forth Replacement Crossing!
REMEMBER, CE MARKING IS PRIMARY LEGISLATION POLICED UNDER CRIMINAL LAW. THE CHAIN OF RESPONSIBILTY/LIABILITY RUNS FROM SUPPLIER TO CONTRACTOR AND PROJECT OWNER WITH PENALTIES OF UP TO £10,000 AND/OR A 3 MONTH CUSTODIAL SENTENCE!
Blake Group received our CE certification and accreditation in April 2014.
Compliance with the CPR.
For all our steelwork projects Blake Group provides the three following documentation to satisfy compliance on any job:-
3). Declaration of Performance (DoP)
Blake’s Certification for FPC and welding are attached to this website and a DoP is produced for every fabrication project.
ALL CONTRACTORS, ENGINEERS AND ARCHITECTS SHOULD SPECIFY THE REQUIREMENT FOR CE MARKED STEELWORK ON TECHNICAL DRAWINGS AND WITHIN PROCUREMENT PACKAGES!
AS A PROJECT CLIENT, YOU ARE ALSO LIABLE FOR NON-COMPLIANCE. MAKE SURE THAT YOUR TEAM HAVE FULLY ACCOUNTED FOR THE CPR!
Should you have further queries on CE Marking and the CPR please contact us……